Листовка для Arkon GN115

Скачать
Страница из 1
5.  Position the Nüvi as desired.
           WARNING:
Do not install Arkon products over an air bag cover or within the air bag 
deployment zone. Arkon Resources, Inc. assumes no responsibility of liability 
for injury or death as a result of car crashes and/or air bag deployment.
Arkon Resources, Inc. is not responsible for any damages caused to your car, 
your device, or yourself due to the installation or use of the pedestal mount.
!
Installation for optional Console Dash Mount (GN115)
6.  To remove, hold the pedestal with one hand 
and firmly pull Nüvi away from pedestal with your 
free hand.
Removal of Dash Mount
To remove the dash mount completely, use a cotton 
swab dipped in isopropyl alcohol. Simply peel up a 
corner of the dash mount adhesive and swab under the 
pad while gently pulling until the adhesive begins to 
release.  Remove slowly.  No damage will occur from 
the adhesive if it has been properly installed and 
removed per these instructions.  You may see a slight 
discoloration between this area and other parts of your 
dash due to fading caused by the sun.
1.  Remove paper liner from adhesive on mount disk 
and affix adhesive to the dash.  Let stand (at room 
temperature) for 24 hours before using.
The Mobile Mounting Specialists™
www.arkon.com
Arcadia, CA 91006 USA
Designed in USA | Made in Taiwan
© Copyright 2009 Arkon Resources, Inc.
Consumer Hotline:
(USA)    (800) 841-0884
(INT’L)   (626) 254-9005
                Mon-Fri. 9am-5pm, PST
2.  Attach Nüvi to mount ball head by firmly pushing ball (A) into 
socket on the back of the device (B) as pictured below.
4. Adjust the angle of the arm by loosening 
the adjustment knob (E). 
3. Push the pedestal suction cup (C) firmly to the 
windshield. Flip the lever (D) toward base to secure 
the suction cup. 
(C)
(D)
(E)
(C)
(D)
(B)
360
o
 swivel
(17mm ball head)
(17mm socket)
(A)
(B)
2. Push the pedestal suction cup (A) down onto the 
disk (D). Flip the lever (B) down to secure the 
suction cup. Adjust the angle of the arm by 
loosening the adjustment knob (C). Poistion Nüvi as 
desired.
(A)
GN115 - GN014 I  Windshield Suction Mount for Garmin® Nüvi
TM
 
Travelmount
TM
 windshield, console, or dash mount for Garmin® 
Nüvi
TM
 and StreetPilot
TM
 portable GPS devices. 
Compatible with ALL Garmin Nüvi portable navigation devices 
including: Nüvi 200, 200w, 205, 205w, 250, 250w, 255, 255w, 
260, 260w, 265T, 265WT, 270, 275T, 300, 300T, 310, 310T, 350, 
360, 360T, 370, 370T, 500, 550, 600, 610, 650, 660, 670, 680, 710, 
750, 755T, 760, 760T, 765T, 770, 775T, 780, 785T, 850, 855 860, 
880, 885T, 1200, 1250, 1260T, 1300, 1350, 1350T, 1370T, 1390T, 
and 5000
Compatible with Garmin StreetPilot models: c310, c510, c530, 
c555, and c580
1. Choose the best location in the vehicle to place the mount.  Do not 
mount in or near an air bag deployment zone or where it will obstruct 
view of the road.