Справочник Пользователя для Advantech 8G ports Industrial Managed Redundant Gigabit Ethernet Switch

 

Set interface ingress limit frame 
type to “accept all frame” 

switch(config)#interface fastEthernet 2 
switch(config-if)#bandwidth type all 

Set interface ingress limit frame 
type to “accept broadcast, 
multicast, and flooded unicast 
frame” 

switch(config)#interface fastEthernet 2 
switch(config-if)#bandwidth type broadcast-
multicast-flooded-unicast

 

Set interface ingress limit frame 
type to “accept broadcast and 
multicast frame” 

switch(config)#interface fastEthernet 2 
switch(config-if)#bandwidth type broadcast-
multicast

 

Set interface ingress limit frame 
type to “only accept broadcast 
frame” 

switch(config)#interface fastEthernet 2 
switch(config-if)#bandwidth type broadcast-only 

[Value] 

Set interface input bandwidth. Rate 
Range is from 100 kbps to 102400 
kbps or to 256000 kbps for giga 
ports, 
and zero means no limit. 

switch(config)#interface fastEthernet 2 
switch(config-if)#bandwidth in 100 

[Value] 

Set interface output bandwidth. 
Rate Range is from 100 kbps to 
102400 kbps or to 256000 kbps for 
giga ports, 
and zero means no limit. 

switch(config)#interface fastEthernet 2 
switch(config-if)#bandwidth out 100 

Show interfaces bandwidth control

switch(config)#interface fastEthernet 2 
switch(config-if)#show bandwidth 

[Enable | Disable] 

Use the state interface 
configuration command to specify 
the state mode of operation for 
Ethernet ports. Use the disable 
form of this command to disable 
the port. 

switch(config)#interface fastEthernet 2 
switch(config-if)#state Disable 

show interface configuration status

switch(config)#interface fastEthernet 2 
switch(config-if)#show interface configuration 

show interface actual status 

switch(config)#interface fastEthernet 2 
switch(config-if)#show interface status 

show interface statistic counter 

switch(config)#interface fastEthernet 2 
switch(config-if)#show interface accounting 

Clear interface accounting 
information 

switch(config)#interface fastEthernet 2 
switch(config-if)#no accounting 

 
 

 

[1~65535] 

Set port group system priority 

switch(config)#aggregator priority 22 

[

Group ID

] 

[Port Numbers] 

Set activity port 

switch(config)#aggregator activityport 2 

[GroupID] [Port-list] 

[Workport]

 

Assign a trunk group with LACP 
active. 
[GroupID] :1~3 
[Port-list]:Member port list, This 
parameter could be a port 
range(ex.1-4) or a port list separate 
by a comma(ex.2, 3, 6) 
[Workport]: The amount of work 
ports, this value could not be less 
than zero or be large than the 
amount of member ports. 

switch(config)#aggregator group 1 1-4 lacp workp 
2

 

or 

switch(config)#aggregator group 2 1,4,3 lacp 
workp 3