Справочник Пользователя для Vulcan-Hart BVP42FP32(F,L)N-1

Page 24

19400-3-0406

A. BEFORE LIGHTING smell all around the appliance area for 

gas. Be sure to smell next to the floor because some gas is 

heavier than air and will settle on the floor.

 

• Do not try to light any appliance

 

• Do not touch any electrical switch

 

• Do not use any phone in your building.

 

• Immediately  call  your  gas  supplier  from  a  neighbor's  

phone.

 

• Follow the gas supplier's instructions.

 

• If  you  can  not  reach  your  gas  supplier,  call  the  fire  

department.

B. Use only the wall switch or remote control switch to turn the 

gas control on/off. Any attempted repairs or adjustments should 

be performed by a qualified service technician. Applying force 

or attempted repair may result in a fire or explosion.

C. Do not use this appliance if any part has been under water. 

Immediately call a qualified service technician to inspect the 

appliance and to replace any part of the control system and 

any gas control which has been under water.

LIGHTING INSTRUCTIONS

FOR YOUR SAFETY READ BEFORE LIGHTING

TO TURN OFF GAS TO APPLIANCE

1. STOP! Read the safety information above.

2. Turn off all electric power to the appliance.

3. Open  bottom  louver  assembly,  or  open  the  valve  access 

door.

4. Turn gas line valve to "OFF."

5. Close bottom louver assembly, or close valve access door.

1. STOP! Read the safety information above.

2. Turn off all electric power to the appliance.

3. This  appliance  is  equipped  with  an  ignition  device  that 

automatically lights the burner. Do not try to light the burner 

by hand.

4. Open bottom louver assembly, or open valve access door.

5. Turn gas line valve to "ON."

6. Wait five (5) minutes to clear out any gas. Then smell for gas, 

including near the floor. If you smell gas, STOP! Follow "A" 

in the safety information on reverse. If you do not smell gas, 

go to the next step.

7. Close bottom louver assembly, or close hearth access plate.

8. Turn on all electric power to the appliance.

9. If the appliance will not operate, follow the instructions "TO 

TURN OFF GAS TO APPLIANCE," and call your service 

technician or gas supplier.

ON

OFF

DIRECT IGNITION LIGHTING INSTRUCTIONS

INITIAL START UP GAS LINE PURGE

NOTE: UNIT MUST BE PROPERLY GROUNDED FOR ELECTRONIC IGNITION TO FUNCTION.

On initial installation, or after extended periods where the fireplace has not been used, gas lines may require purging.