Справочник Пользователя для Snapper LT145H38FBV

 

1.  Front Wheel Bearings 
Lubricate each front wheel bearing through the 
grease fitting on wheel hub. Using general purpose 
grease in a grease gun, add grease until grease 
purges from bearing. See Figure 3.6. 

 

 

FIGURE 3.6 

 

Lubricate each axle spindle with 1 to 3 shots of 
general purpose grease.  See Figure 3.6. 

 
NOTE:  The right hand spindle fitting faces forward and 
the left hand spindle fitting faces to the rear. 

The clutch/brake pivot is located on the left hand 
underside of the tractor and is lubricated with one 
shot of general purpose grease. See Figure 3.7. 

 

 

 

FIGURE 3.7 

 
 
 
 
 

4.  Steering Sector Gear 
Lubricate with a light coat of general purpose grease. 
See Figure 3.8. 

 

 

FIGURE 3.8 

 

Lubricate steering shaft wear points with a light coat 
of SAE30 oil. 
 
6.  Steering Drag Link 
Lubricate both ends of steering drag link with a small 
amount of SAE30 oil. See Figure 3.9. 

 

FIGURE 3.9