Справочник Пользователя для Snapper LT145H38FBV

 

 
NOTE: Before adjusting deck, bring tire pressure to 
proper P.S.I.; front 12 P.S.I., rear 12 P.S.I.. 
 
1.  Move tractor to a firm, level surface. 
2.  Turn engine “OFF”. Remove key.  
3.  Place a 2-1/2” tall block under the front of the deck 
centered between the front lift arms. See Figure 4.13. 

 

 

FIGURE 4.13 

 
4.  Place a 1-3/4" tall block under the rear of the deck in 
the center. See Figure 4.13. 
5.  Position blades as shown and lower deck onto 
blocks. See Figure 4.13. 
6.  Disconnect the front lift rod and the rear hanger 
plates. See Figure 4.14. 
7.  Put the lift lever in the 3rd position from low cut. 
8.  Measure the distance from each blade tip to the 
floor. The measurements should be within 1/8" of each 
other. (Factory setting) 
 
 

 

FIGURE 4.14 

 

9.  If the difference is less than 1/8", go to next section, 
Front to rear level. If the difference is more than 1/8", 
adjust as described in the following steps. 
10. 

Loosen the front adjuster nut until adjuster moves 

freely. Then tighten the nut until the adjuster moves only 
when moderate force is applied to one side of the deck. 
See Figure 4.15. 

 

FIGURE 4.15 

 

Adjust the side to side level of the blade tips by 

moving one side of the deck up or down as needed to 
obtain 1/8" or less side to side deck level. 
12. 

After leveling deck, retighten the adjuster nut using 

30 to 40 ft. lbs. 
13. 

Attach the rear hanger plates to the hole that most 

closely aligns with the pin on the deck lift bracket. Secure 
with washer and hair pin. 
14. 

Adjust the swivel on the front lift rod until it lines up 

with the hole in the front lift bracket. (Make sure the lift 
rod is at the top of the slot in the deck bracket) Secure 
with hair pin.