Справочник Пользователя для Vulcan-Hart 924RE

— 5 —

F35628 (10-04)

WARNING: DISCONNECT THE ELECTRICAL

POWER TO THE MACHINE AND
FOLLOW LOCKOUT / TAGOUT
PROCEDURES.

1. Remove the two screws securing the

control panel. One screw is located at
each end of the control panel.

2. Pull the control panel forward and

disconnect the electrical connector near
the right end.

3. Reverse the procedure to install.

WARNING: DISCONNECT THE ELECTRICAL

POWER TO THE MACHINE AND
FOLLOW LOCKOUT / TAGOUT
PROCEDURES.

1. Remove control panel.

2. The bullnose weld assembly is secured

with two screws, one on each side of the
bottom of the assembly.  Remove these
screws, then remove the bullnose weld
assembly from the griddle.

3. Reverse the procedure to install.

1. Remove control panel.

2. The heat shield clamps on the front of the

griddle and can be removed by grasping
the top of the shield and pulling forward.

3. Reverse the procedure to install.

1. Remove all screws from rear of griddle

securing the back panel.

2. Remove the back panel. (See Figure D)

3. Reverse procedures to install.