Инструкция С Настройками для JVC GR-DVP9
42
EN
Master Page: Left
● If Program AE with special effects (墌 pg. 33) is
engaged, certain modes of Program AE with
special effects are disabled during Snapshot
recording. In such a case, the icon blinks.
special effects are disabled during Snapshot
recording. In such a case, the icon blinks.
● If SNAPSHOT is pressed when “DIS” is set to
墌 pg. 36), the Stabiliser will be disabled.
● During playback as well, all snapshot modes
except Nega mode are available when
“
“
COPY” is set to “OFF” in VIDEO Menu.
墌 pg. 40) However, the shutter sound is not
heard.
● During Snapshot recording, the image displayed
in the viewfinder may be partially missing.
However, there is no effect in the recorded image.
However, there is no effect in the recorded image.
● When the S/AV/Editing cable is connected to the
S/AV connector, the shutter sound is not heard
from the speaker, however it is recorded onto the
tape.
from the speaker, however it is recorded onto the
tape.
Motor Drive Mode
Keeping SNAPSHOT pressed in step 5 provides an
effect similar to serial photography. (Interval
between still images: approx. 1 second)
effect similar to serial photography. (Interval
between still images: approx. 1 second)
● The Motor Drive mode is disabled when “REC
SELECT” is set to “
/
Once the camcorder is set, the camcorder operator
can become part of the scene in a more natural way,
adding the final touch to a memorable picture.
can become part of the scene in a more natural way,
adding the final touch to a memorable picture.
1
Set the Power Switch to “M” while pressing down
the Lock Button located on the switch.
the Lock Button located on the switch.
2
Open the LCD monitor fully, or pull out the
viewfinder fully.
viewfinder fully.
● You can tilt the LCD monitor upward to 180°
so that it faces forward and view yourself while
self-recording with the viewfinder pushed
back.
self-recording with the viewfinder pushed
back.
3
Set “SELF-TIMER” to
“ON
“ON
”. (
4
To engage the Self-Timer
for video recording, press
the Recording Start/Stop
Button.
for video recording, press
the Recording Start/Stop
Button.
● After 15 seconds, the
beep sounds and video
recording starts.
recording starts.
5
To stop Self-Timer recording, press the Recording
Start/Stop Button again.
Start/Stop Button again.
● The camcorder re-enters Record-Standby
mode.
OR
5
Press SNAPSHOT.
● After 15 seconds, the beep sounds and
snapshot recording starts. After that, the
camcorder re-enters Record-Standby mode.
camcorder re-enters Record-Standby mode.
6
To end Self-Timer recording, select “OFF” in
step 3.
step 3.
NOTE:
If “BEEP” and “TALLY” are set to “OFF” (
If “BEEP” and “TALLY” are set to “OFF” (
the beep does not sound and the tally lamp does not
light.
light.
Self-Timer
NU
L
MA
A
O
ME
L
– T I
SE F
R
F
F
–
N
RETUR
ON
Self-Timer indication
When the Recording Start/Stop Button or SNAPSHOT
is pressed, the tally lamp changes as shown:
Begins blinking
(Self-Timer starts)
Blinks quickly
(Self-Timer shooting starts
soon)
Stops blinking and stays on
(Self-Timer video recording
starts)
OR
Turns off
(Self-Timer snapshot
recording occurs)
After approx.
15 sec.
GR-DVP9Asia.book Page 42 Monday, February 10, 2003 1:12 PM