Инструкция С Настройками для JVC GR-DVP9
52
EN
Master Page: Left
It is also possible to copy recorded scenes from
another video unit equipped with a DV connector
onto the camcorder. Since a digital signal is sent,
there is little if any image or sound deterioration.
another video unit equipped with a DV connector
onto the camcorder. Since a digital signal is sent,
there is little if any image or sound deterioration.
* When connecting the cable, open the cover.
1
Make sure all units are turned off.
2
Connect this camcorder to a video unit equipped
with a DV output connector using a DV cable as
shown in the illustration.
with a DV output connector using a DV cable as
shown in the illustration.
3
Set this camcorder’s VIDEO/MEMORY Switch to
“VIDEO”.
“VIDEO”.
4
Set this camcorder’s Power Switch to “P”
while pressing down the Lock Button located on
the switch.
while pressing down the Lock Button located on
the switch.
5
Set “REC MODE” to “SP” or “LP”. (
6
Turn on the video unit’s power.
7
Insert the source cassette in the video unit.
8
Insert the recording cassette in this camcorder.
9
Press START/STOP on the remote control to
engage the Record-Pause mode.
engage the Record-Pause mode.
● The “
” indication appears on the screen.
10
Press START/STOP on the remote control to
start recording.
● The
indication rotates.
11
Press START/STOP on the remote control
again to engage the Record-Pause mode.
● The
indication stops rotating.
12
Repeat steps 10 – 11 for additional editing.
Stop the video unit and camcorder.
NOTES:
● It is recommended to use the AC Power Adapter/
Charger as the power supply instead of the
battery pack. (
battery pack. (
● If no image is displayed on the LCD monitor, set
“S/AV INPUT” to “OFF”. (
● If the remote control is used when both the player
and recorder are JVC video units, both units will
perform the same operation. To prevent this from
happening, press the buttons on both units.
perform the same operation. To prevent this from
happening, press the buttons on both units.
● If a blank portion or disturbed image is played
back on the player during dubbing, the dubbing
may stop so that an unusual image is not dubbed.
may stop so that an unusual image is not dubbed.
● Even though the DV cable is connected correctly,
sometimes the image may not appear in step 9. If
this occurs, turn off the power and make
connections again.
this occurs, turn off the power and make
connections again.
● Digital Dubbing is performed in the sound mode
recorded on the original tape, regardless of the
current “SOUND MODE” setting. (
current “SOUND MODE” setting. (
● When using a DV cable, be sure to use the
optional JVC VC-VDV204U DV cable.
Dubbing From A Video Unit
Equipped With A DV OUT
Connector (Digital Dubbing)
Equipped With A DV OUT
Connector (Digital Dubbing)
Core filter
To DV IN/OUT
DV cable (optional)
To DV OUT
Video unit equipped with DV
connector
Connector
Cover*
DV. IN
GR-DVP9Asia.book Page 52 Monday, February 10, 2003 1:12 PM