Инструкции По Установке для Bosch ltc-0335-28

114 en | Encoders / Decoders page

Bosch Video Management System

Configuration Client | V3 | 2010.07

Configuration Manual

Bosch Sicherheitssysteme GmbH

–

No alarm message is displayed in the video image.

–

Enter the position where a message is displayed in the video image in case of an alarm.

Allows you to activate or deactivate the 75 Ohm terminating resistor for each video input. 

The numbering follows the labeling of the video inputs on the device. Every video input is 

closed at the time of delivery.

Select one of the following:

–

Off: Deactivates the 75 Ohm terminating resistor and loops through the video signal.

–

On: Activates the 75 Ohm terminating resistor. No loop through of the video signal.

Allows you to adjust each video image to your requirements. All changes are displayed 

immediately. Be aware that changes in the image quality affects processor performance.

Enter the number of the camera you want to adjust. If you want to do this for each camera, 

enter the number of the camera, adjust the settings (brightness, contrast, etc.), and then 

enter the next camera number, and adjust their settings.

Enter the value to adjust the brightness of the video image to your working environment.

Enter the value to adjust the contrast of the video image to your working environment.

Enter the value to adjust the color saturation of the video image on your monitor as realistic as 

possible.

Enter the value to remove very fine noise from the image. This reduces and optimizes the 

bandwidth necessary for the image transmission over the network. The image resolution may 

be impaired. The higher the value, the flatter the image signal. 

Click to change the current settings to the factory settings.

Click to display the image window of the encoder. In the menu bar of the video image you can 

select the video input that you want to display.

Allows you to connect video recorders as video source. Video recorders require a more 

tolerant setting as a result of unwanted effects caused by the mechanical components of a 

video recorder.

Select VCR to connect video recorders as video source. Select Camera to connect cameras.

In some cases, selecting VCR also for cameras can lead to an improvement in the video image.