Инструкции По Установке для Bosch ltc-0335-28

126 en | Encoders / Decoders page

Bosch Video Management System

Configuration Client | V3 | 2010.07

Configuration Manual

Bosch Sicherheitssysteme GmbH

This function allows you to save individual JPEG images on an FTP server at specific intervals. 

Then, retrieve these images at a later date to reconstruct alarm events, if required.

Select the resolution for the JPEG images.

Select how file names are created for the individual images that are transmitted.

–

The same file name is always used. An existing file is overwritten by the current file.

–

A number from 000 to 255 is added to the file name and automatically incremented by 1. 

When the number reaches 255, the number starts again from 000.

–

The date and time are automatically added to the file name. Ensure that the date and 

time of the device are always set correctly. For example, the file 

snap011008_114530.jpg was stored on October 1, 2008 at 11.45 and 30 seconds.

Enter the interval in seconds at which the images is sent to an FTP server. Enter zero for no 

images to be sent.

Type the IP address of the FTP server on which to save the JPEG images.

Type your login name for the FTP server.

Type the password for the FTP server.

Type the exact path where to save the images on the FTP server.

Select the check box to activate the camera input for the JPEG image. The numbering follows 

the labeling of the video inputs on the device.

This page allows you to enable additional functions or software modules.

Displays the installation code.

Type the activation key. The activation key cannot be deactivated and is not transferable to 

other units.

Displays the installed licenses after their activation.