Инструкции По Установке для Bosch ltc-0335-28

Bosch Video Management System

 Cameras and Recording page | en

Bosch Sicherheitssysteme GmbH

Configuration Manual

Configuration Client | V3 | 2010.07

Main window > 

 Cameras and Recording > Click an icon for recording device, for 

example 

 > Click a Recording Schedule tab (for example 

)

Allows you to configure the recording settings for all encoders assigned to your system.

The displayed Recording Schedules are configured in Schedules.

Only those columns are described that are not part of a Camera Table.


Click a column title to sort the table by this column. 

Allows you to start or stop recording for this encoder. 

In the Mode column, select the recording mode:

–

Continuous: The settings in the next 2 columns are valid for continuous recording.

–

Prealarm: The settings in the next 2 columns are valid for alarm recording.

In the Quality column, click a cell to select the stream quality of stream 1.

If you select Prealarm as the recording mode, click a cell in the Duration [s] column to select 

the alarm recording time before the alarm in seconds. The effective recording duration 

depends on the maximum target bit rate configured for this encoder. We recommend 

configuring at least 15 seconds.

In the Stream column, select the stream that is recorded in case of an alarm. The settings in 

the next 2 columns are valid for the selected stream. Stream 2 is only selectable for encoders 

running ARM firmware.

In the Alarm Quality column, click a cell to select the stream quality of the selected stream.

Only for ARM Firmware: When you select the No modification entry, the same quality is used 

for continuous and for alarm recording without any modification. We recommend using the No 

modification entry. When you select a stream quality profile, only the values for image 

encoding interval and target bit rate are modified according to the settings in this stream 

quality profile.

In the Duration [s] column, click a cell to select the alarm recording time in seconds. The 

effective recording duration depends on the maximum target bit rate configured for this 

encoder. We recommend configuring at least 15 seconds.

To start alarm recording, configure a corresponding alarm or start manual recording in the 

Operator Client.

In the Quality column, click a cell to disable recording or to select the stream quality of 

stream 1.

In the 

 column, select a check box to activate audio.

In the Quality column, click a cell to select the stream quality of the live view (required for 

instant playback) and the pre-event recording (required for motion and alarm recording) mode 

of stream 2. If dual streaming is active on this encoder, you can select stream 1 to use for live 

or pre-event recording.

In the 

 column, select a check box to activate audio.