Руководство Пользователя для Bosch hdi7052u

Conversion

English 3

1. Remove Warming Drawer; Pull drawer out until stop is reached. Facing the 

range, push clip on left side up and clip on right side down. Pull drawer the 
rest of the way out.

2. Remove cover plate from interior back wall by removing single screw on left 

side of panel. Use a torx T-20 head screwdriver.

3. Remove the hexagon cap from the top of the regulator with an adjustable 

wrench.

4. Pop out the plastic stem in the cap and turn it over pressing it firmly in place 

so that the letters "LP" (rather than "NAT") are seen upright in the stem.

5. Replace the cap and button assembly into the top of the regulator sealing it 

firmly. Make certain spring is still in place (See Fig. 1). DO NOT OVER 
TIGHTEN. 

7. Fill out and affix the CONVERSION STICKER on the back side of the cover 

plate so that it appears on the back side of range next to the regulator.

1. Remove Grates, Burner Caps and Burner Bases. 

Unscrew two (2) T20 screws inside each base and remove  burner bases. 
Reinsert screws in jet holder to hold tubing assembly in place.

3. Remove Natural Gas Cooktop Orifices. 

Insert the socket driver with 3" minimum extension into the jet holders to 
remove existing orifices. Set natural gas orficies aside.

4. Assemble LP Cooktop Orifices. 

Place in cooktop exactly as laid out in the orifice card. If the orifices become 
separated from the card, placement can be determined by matching the num-
ber and/or color on the orifice with the placement specifications displayed in 
the chart on the card

NA
T

LP

NAT

Hex 
Cap

    Pin
Position
 for Nat.
    Gas

Pin

Pin Position
for Propane

Hex 
Cap

LP

Pin

Spring

Burner Grate

Burner Cap

Burner Base

Orifice

Ignitor