Справочное Руководство для Alcatel-Lucent 6850-48
OmniSwitch CLI Reference Guide
September 2009
page 53-1
53 QoS Policy Commands
This chapter describes CLI commands used for policy management in the switch. The Quality of Service
(QoS) software in the switch uses policy rules for classifying incoming flows and deciding how to treat
outgoing flows. A policy rule is made up of a policy condition and a policy action. Policy rules may be
created on the switch through CLI or SNMP commands, or they may be created through the PolicyView
GUI application on an attached LDAP server.
(QoS) software in the switch uses policy rules for classifying incoming flows and deciding how to treat
outgoing flows. A policy rule is made up of a policy condition and a policy action. Policy rules may be
created on the switch through CLI or SNMP commands, or they may be created through the PolicyView
GUI application on an attached LDAP server.
Note. Rules created through PolicyView cannot be modified through the CLI; however, you can create
policies in the CLI that take precedence over policies created through PolicyView.
policies in the CLI that take precedence over policies created through PolicyView.
Refer to
Chapter 43, “QoS Commands,”
for information about commands used to configure QoS software.
MIB information for the QoS policy commands is as follows:
Filename: alcatelIND1Qos.mib
Module
Module
ALCATEL-IND1-QoS-MIB
Important Note. Some of the commands listed here are not currently supported on one or more plat-
forms. See command descriptions in this chapter and check release notes for information about commands
that are not supported.
forms. See command descriptions in this chapter and check release notes for information about commands
that are not supported.
The QoS Policy commands are listed here:
Policy commands