Руководство Пользователя для Sony PMW-320K

Advanced Operations

76

Ch
apt
er 4  

S

hoo
tin

g

“INT REC” and “INT STBY” appear 
alternatively at the position of the REC 
indication. The TALLY indicators and the tally 
indicator on the front panel of the viewfinder light 
as they do during normal recording.
If you are using the pre-lighting function, the 
video light comes on before recording starts.

To stop shooting
Stop the recording.

When shooting ends, the video data stored in 
memory up to that point is written to the media.

To exit Interval Rec mode
Do one of the following.
• Set the POWER switch to OFF.
• With the camcorder in recording standby mode, 

set OPERATION >Rec Function >Interval Rec 
in the setup menu to “Off”.

Limitations during recording
• The i.LINK (HDV/DV) connector cannot be 

used.

• Regardless of the setting of the F-RUN/SET/

R-RUN switch, the advance mode of the 
internal timecode generator is always F-RUN.

• Audio cannot be recorded.
• Recording review is not possible.
• If you press the SLOT SELECT button, the 

camcorder completes recording of the specified 
number of frames, creates a clip, and switches 
to the other media.

• Genlock is not possible.

If power is lost during recording
• If you set the camcorder’s POWER switch to 

OFF, the camcorder is powered off 
automatically after a few seconds, during which 
the media is accessed to record the video and 
audio data stored in the camcorder’s memory up 
to that point.

• If power is lost because the battery was 

removed, the DC cable was disconnected, or the 
power was turned off on the AC adaptor side, 
then the video and audio data shot up to that 
point may be lost (maximum 10 seconds). Be 
careful to avoid this when exchanging the 
battery.

The Frame Rec function is useful for shooting 
stop motion animations, such as animations with 
puppets or clay figures.
Each time that you press the recording start 
button, the camcorder shoots a specified number 
of frames and then stops.

• The Frame Rec function cannot be used at the same 

time as the picture cache, Interval Rec, or Slow & 
Quick Motion function. When you select Frame Rec 
mode, the picture cache, Interval Rec, and Slow & 
Quick Motion functions are disabled. When you select 
picture cache, Interval Rec, or Slow & Quick Motion 
mode, the Frame Rec function is disabled.

• The data stored in memory is cleared when you change 

the system settings, for example by selecting a 
different video format. Picture data from before the 
change is not recorded even if you start recording 
immediately after the change. The camcorder exits 
Frame Rec mode automatically.

• Frame Rec settings cannot be changed during 

recording.

• Frame Rec is disabled when the following formats are 

selected.
- SP 1440/59.94i or SP 1440/50i, when the output 

setting is HD and OPERATION >Input/Output 
>i.LINK I/O in the setup menu is set to Enable

- SP 1440/23.98P (pull-down recording)
- Other than HQ 1920/23.98P or HQ 1280/23.98P, 

when the output setting is SD and OPERATION 
>Input/Output >i.LINK I/O in the setup menu is set 
to Enable

Turn the MENU knob to select [On], 
and then press the knob. 
The camcorder enters Frame Rec mode, the 
“Frame Rec” indication on the viewfinder 
screen flashes.