Руководство Пользователя для RCA drd221rd

Follow these steps whenever you need to install or change the batteries
in your remote control

1.

Remove the cover from the battery compartment.

2.

Insert batteries in the battery compartment, matching the +
and – end of each battery.

3.

Replace the cover.

Plug the end into the wall outlet, matching the wide blade of the plug
with the wide slot in the outlet. Be sure to insert the plug completely.

To turn on the DIRECTV System, press the DIRECTV button on the remote
control or the ON•OFF button on the front panel of the digital satellite
receiver. If your TV brand is RCA, GE, or PROSCAN, press the TV button
on the remote to turn on the TV. If your TV brand is not RCA, GE, or
PROSCAN, see the next section, “Using the Remote,” for details on
how to use the remote to control your TV.

After you have installed your DIRECTV System, you should contact the
service providers, DIRECTV and USSB, to receive programming.

Programming with DIRECTV:

Call 1-800-347-3288

Programming with USSB:

Call 1-800-204-USSB

If you self-installed your satellite dish antenna, you may have
already used the interactive setup to find the dish pointing
coordinates, acquire and fine-tune the signal, and run a test of your
DIRECTV System.

If you need to run the interactive setup again, select Options from
the Main menu, then select Interactive Setup.

If you did not self-install the satellite dish antenna, you may just
want to check your dish pointing coordinates, or run the signal
strength meter. Select Dish Pointing from the Main menu.

When you order programming, you need
to know your access card number. To get
the number, select Options from the Main
menu, then System Options, and then
select System Test.