Руководство Пользователя для RCA dtc-100

Follow these steps whenever you need to install or change the batteries in your remote
control.

1.

Remove the cover from the battery compartment.

2.

Insert batteries into the battery compartment, matching
the + and – end of each battery.

3.

Replace the cover.

1.

Plug the power cord into a wall outlet. Be sure to insert the plugs completely.

2.

To turn on the HD receiver, press the HD RCVR button

 

 on the remote control or the

ON button on the front panel. When on, the button is illuminated.

3.

If you are using a MultiMedia or HD monitor and have connected a VGA cable to the
HD RECEIVER OUT jack, make sure the front panel button labeled HD MONITOR is
illuminated.

If you self-installed your satellite dish antenna, you may have already used the interactive
setup to find the dish pointing coordinates, acquire and fine-tune the signal, and run a
system test.

If you need to run the interactive setup again, press MENU on the remote control, select
Assistance from the main menu, then select Interactive Setup. For more details, see the
section “Getting Assistance” in this book.

If you just want to check your dish pointing coordinates or run the signal strength meter,
select Assistance from the main menu, then select Dish Pointing.

To select a screen format:

1.

Press MENU on the remote control.

2.

Select Preferences from the main menu.

3.

Then select Screen Format.

4.

Use the arrows and OK buttons on the remote control to specify the aspect ratio of
the TV or monitor you are using with your HD receiver.

If you have a 4:3 ratio monitor, you need to specify how an image with a 16:9 ratio is
displayed: Letterbox or Cropped.

If you have a 16:9 ratio monitor, you need to specify how an image with a 4:3 ratio is
displayed: Normal, Full, or Fill.

For more details on how the images are displayed, see the section in this book called
“System Options and Preferences.”