Справочник Пользователя для RCA DRC8000N

This remote control is designed to operate most RCA, GE, and Proscan TVs.

1.

Press the TV button.

2.

Press the ON•OFF button (if the TV turns on or off, this remote will operate the TV).

3.

If that doesn’t work, you can try programming the remote by following the
instructions below.

There are two ways to program this remote control to operate other brands of TVs:
Direct Entry and Automatic Code Search (both methods are described below).

1.

Turn on the TV.

2.

Look up the brand and code number(s) from the list on page 23.

3.

Press and hold the TV button on the remote.

4.

Keep holding down the TV button, and enter the first code from the code list for your
brand (p. 23).

5.

Release the TV button.

6.

Point the remote toward the TV and press the ON•OFF button to see if the TV turns
off. If it doesn’t, press the TV button and then press ON•OFF. If you get no response,
follow steps 1-5 again, but enter the next code from the code list for your brand of
television.

The Automatic Code Search method tests all of the codes for a specific component
button. If you want to stop the automatic code search without programming any of your
components, press CLEAR until the indicator on the remote turns off.

1.

Turn on the TV.

2.

Press and hold the TV button.While you continue pressing the TV button, press and
hold the ON•OFF button until the indicator light on the remote turns on— then
release both buttons.

3.

Point the remote at the TV. Press and release PLAY, then wait 5 seconds or until the
indicator on the remote stops flashing.

At this point the remote is searching for the correct code to program (you’ll know it’s
found the correct code when the TV turns off, go to step 4). If, after 5 seconds, the TV
doesn’t turn off, press PLAY again to tell the remote to search the next set of codes.

Continue pressing PLAY until the TV turns off or you have searched through all of the
codes.There are 20 total sets of codes. If the component does not turn off after
pressing PLAY 20 times, then the remote can’t be programmed to operate your brand
of TV— you’ll have to use the remote that came with your TV.

4.

When the TV turns off, the remote has found the proper code. Press and release
REVERSE, then wait 2 seconds. Repeat this step until the TV turns back ON.

5.

To finish, press and hold STOP until the indicator on the remote turns off.

Graphics contained within this publication are for representation only.