Справочник Пользователя для RCA D52W25

Chapter 1: Connections & Setup

Connections & Setup

•    Connect all components before you plug any of their power cords into the wall outlet.

•    Turn off the TV and/or component before you connect or disconnect any cables.

•    Make sure all antennas and cables are properly grounded. Refer to the Important Safety 

Instructions on page 1.

•    Don’t block ventilation holes on any of the components. Arrange the components so that air 

can circulate freely.

•    Don’t stack components.

•    If you place components in a stand, make sure you allow adequate ventilation.

•    If you connect an audio receiver or amplifier, place it on the top shelf so the heated air from it 

won’t flow around other components.

•    Insert each cable firmly into the designated jack.

•    If you place components above the TV, route all cables down the side of the back of the TV 

instead of straight down the middle of the TV.

•    If your antenna uses 300-ohm twin lead cables, do not coil the cables. Also, keep the twin 

lead cables away from audio/video cables.

Choose the location for your TV carefully. Place the TV on a stand or base that is of adequate size 
and strength to prevent the TV from being accidentally tipped over, pushed off, or pulled off. This 
could cause personal injury and/or damage the TV. Refer to the Important Safety Instructions on 
page 1.

Don’t place the TV where sunlight or room lighting will be directed toward the screen. Use soft or 
indirect lighting.