Руководство Пользователя для NAD VISO TWO

AC power unplugged.

•

Check AC cable connection and outlet.

•

Power not switched on.

•

Outlet has no power.

•

Faulty/missing cables.

•

Check cables.

•

Speaker connections faulty.

•

Check speaker connections.

•

“Speaker Settings” channel (s) set to “Off”.

•

Check “Speaker Settings” menu.

•

Subwoofer is off, not powered or improperly 

connected.

•

Power-up subwoofer, check Sub’s AC outlet 

or check connections.

•

Sub level set too low.

•

Correct subwoofer level by adjusting “SUB” 

button at HTR 6.

•

Batteries are flat or incorrectly inserted.

•

Check batteries.

•

IR transmitter window on remote or IR receiver 

window on VISO TWO is obstructed.

•

Check IR windows and ensure clear line-of-

sight from remote to VISO TWO.

•

VISO TWO front panel is in very bright sunlight 

or ambient light.

•

Reduce sunlight/room lighting.

•

Microprocessor error.

•

Power down the VISO TWO via the front 

panel Power switch and unplug it from the 

AC outlet.

•

VISO TWO may have over heated.

•

Wait five minutes, re-connect and power up.

•

No disc is inserted.

•

Insert a disc. 

•

The TV is not set to receive video signal.

•

Select the appropriate video input mode 

on the TV so that the picture from the 

VISO TWO appears on the TV screen output.

•

The video cable is not connected securely. 

•

Connect the video cable into the jacks 

securely.

•

The connected TV power is turned off.

•

Power on the TV.

•

HDMI connector is plugged-in and “HDMI Res.” 

is set to 720P, 1080I or AUTO. 

•

Unplug HDMI cable connected to  rear 

panel’s HDMI OUT.

•

At DVD mode and with no disc loaded (“NO 

DISC”)

1  Press and hold [DISPLAY] button. The lower 

line of the VFD will show the current HDMI 

resolution setting. 

 Use the remote’s [ 

 ] keys or toggle 

[MEMORY] button to select through 

480P/576P, 720P, 1080I, AUTO or OFF. 

Select either “480P/576P” or “OFF” to enable 

component video out, composite and S-Video 

output.  Stop at your desired resolution setting 

and release [ 

 ] keys or [MEMORY] button.

•

The disc is dirty. 

•

Clean the disc.

•

No disc is inserted.

•

Insert a disc

•

An unplayable disc is inserted.

•

Insert a playable disc (Check the disc type 

colour system and Regional code).

•

The disc is placed upside down.

•

Place the disc with the playback side down.

•

The disc is not placed within the guide. 

•

Place the disc correctly inside the guide on 

the disc tray.

•

A menu is on the TV screen.

•

Press SETUP button of HTR 6 to turn off the 

menu screen.

•

The disc is dirty.

•

Clean the disc.

•

The password entered was wrong.

•

Enter the correct password.

•

Password was forgotten.

•

Set the VISO TWO to factory default settings. 

1  Place the VISO TWO into AM mode.

 Press quickly the three front panel buttons; 

[PLAY/PAUSE] then [STOP] then [DISPLAY], 

holding the [DISPLAY] button for more than 

7 seconds.  The VISO TWO will switch itself 

off then back on to DVD mode.

Note: Default password is 2580.

•