Справочник Пользователя для Printronix SL4M
136
Chapter
4
INTERFACES Menu
•
Framing Errors. These are possible errors that can occur when serial
interface settings of the printer do not match those of the host computer.
interface settings of the printer do not match those of the host computer.
•
Enable (factory default). If a framing error occurs, a fault message
will display on the control panel.
will display on the control panel.
•
Disable. If a framing error occurs, a fault message will not display on
the control panel.
the control panel.
Printer Mgmt
•
PNE Port. This menu selects which port the printer expects PNE to
connect to, via Ethernet or Serial. The factory default is Disable.
connect to, via Ethernet or Serial. The factory default is Disable.
•
Mgmt Protocol. Since PXML and UCP management protocols share the
same Ethernet Port, only one can be active at a time. This menu selects
the active Management Protocol Interface, either PXML or UCP. The
factory default is PXML.
same Ethernet Port, only one can be active at a time. This menu selects
the active Management Protocol Interface, either PXML or UCP. The
factory default is PXML.
•
Select Port
•
Debug (factory default). If the PNE Port is set to Serial then the PNE
will communicate through the Debug Serial Port.
will communicate through the Debug Serial Port.
•
Host. If the PNE Port is set to Serial then the PNE will communicate
through the Host Serial Port. This cannot be selected if Host Interface
is set to Auto Switching or Serial.
through the Host Serial Port. This cannot be selected if Host Interface
is set to Auto Switching or Serial.
•
Baud Rate. Sets the baud rate of the serial interface used to
communicate to the PNE. Baud rate is the speed at which serial data is
transferred between the PNE and the printer. The options for the RS-232
interface are 600, 1200, 2400, 4800, 9600, 19200, 38400, 57600, and
115200 Baud.
communicate to the PNE. Baud rate is the speed at which serial data is
transferred between the PNE and the printer. The options for the RS-232
interface are 600, 1200, 2400, 4800, 9600, 19200, 38400, 57600, and
115200 Baud.
•
Word Length. Sets the length of the serial data word. The length of the
data word can be set to 7 or 8 bits and must match the corresponding
data bits setting in the PNE. The factory default is 8.
data word can be set to 7 or 8 bits and must match the corresponding
data bits setting in the PNE. The factory default is 8.
Table 12. ENQ Status Byte
Bit
Printer Status
0
Set when the label has printed.
1
Set when the label is presented.
2
Set while the printer is online.
3
Always set.
4
Set printing in the batch mode.
5
Set during a Ribbon fault.
6
Set during a Paper Out fault.
7
Set during a Head Open fault.