Инструкция С Настройками для Contax nx
For example, if the ABC Exposure is used at the 18th frame, the exposure
counter is as follows:
counter is as follows:
1st frame
2nd frame
3rd frame
4th frame
Focus position
Standard
Over
Under
(repeated)
Standard
Counter
18
19
20
21
Display
Both left and
Left flashing
Right flashing
Both left and
right flashing
right flashing
• When used with exposure compensation in the ABC Exposure mode, the exposure value
is used as the base value for autobracketing.
• Metering is repeated for each photograph, and compensation determined for the metered
value at that time. It is recommended that the AE lock be set before beginning photogra-
phy if autobracketing without the effects of changing brightness is required.
phy if autobracketing without the effects of changing brightness is required.
• If the compensation range exceeds the compensation limits of the camera, photographs
are taken at the limit of the possible compensation values.
• If the main switch is turned “OFF” and “ON” again in the ABC Exposure mode, ABC pho-
tography begins again from the first frame for three frames.
• The flash cannot be used in the ABC Exposure mode.
“
” The compensation sequence may be changed to over-exposure
→ standard expo-
sure
→ under-exposure (page 87).
65
Use this mode to include yourself in the photograph.
Set the drive mode to "
".
For instructions on setting the drive
mode, see page 31.
mode, see page 31.
Adjust the focus, then press the
shutter button.
shutter button.
The selftimer is activated and the shut-
ter is released after 10 seconds. The
selftimer LED on the front of the camera
flashes while the selftimer is operating.
ter is released after 10 seconds. The
selftimer LED on the front of the camera
flashes while the selftimer is operating.
64
Standard
Under
Over
Display panel
Set to selftimer mode
Selftimer LED
4. Using the selftimer
• When using the selftimer, light entering the viewfinder when the eye is moved away may
interfere with a correct reading of incident light. In such cases, fit the viewfinder shade
adapter to the viewfinder before taking photographs. (page 14)
adapter to the viewfinder before taking photographs. (page 14)
• Use a tripod when taking photographs with the selftimer.
• The selftimer cannot be used when the bulb mode is set.
• If the shutter button is pressed after the selftimer has been activated, the selftimer time is
reset.
• To cancel the selftimer after it has been activated, turn the main switch off.
09-1BC(E)_P050-70 11/15/01 7:28 PM Page 64