Руководство Пользователя для Netopia 3220-h
Configuring Your Cayman 3220-H
Cayman 3220-H User’s Guide
3-48
December 2000
3.
Use the
IP Interface radio buttons to enable or disable IP
traffic over this virtual circuit.
4.
Use the
NAT radio buttons to enable or disable network
address translation for this virtual circuit.
5.
Enter the IP address the Cayman 3220-H will use on this
virtual circuit in the
virtual circuit in the
IP Address field.
The IP address you enter must not be in use by other devices on
this virtual circuit. Enter
this virtual circuit. Enter
0.0.0.0
if you want the Cayman
3220-H to receive the IP address information for this interface
from a DHCP server on the other end of the ATM connection.
from a DHCP server on the other end of the ATM connection.
6.
Enter the subnet mask for the network connected to this
virtual circuit in the
virtual circuit in the
Net Mask field.
The subnet mask specifies which bits of the 32-bit binary IP
address represent network information. Most sites should use
255.255.255.0 for their subnet mask.
address represent network information. Most sites should use
255.255.255.0 for their subnet mask.
7.
Use the
Admin Restrictions list to specify whether the
Cayman 3220-H accepts administrative commands
received over this virtual circuit.
received over this virtual circuit.
Options are:
None – All traffic is accepted over this port.
Admin-Disabled – Router traffic is accepted over this port
but administration commands are ignored.
but administration commands are ignored.
Admin-Only – Administration commands are accepted over
this port but router traffic is ignored.
this port but router traffic is ignored.
8.
Use the
RIP-Send list to specify whether you want the
Cayman 3220-H to send Routing Information Protocol
(RIP) messages to other routers.
(RIP) messages to other routers.
RIP lets your Cayman 3220-H inform other routers of routes
available through its interfaces. Options are:
available through its interfaces. Options are:
Off – Do not send RIP messages to other routers.
RIP-1 – Broadcast routing information in RIP version 1
format.
format.