Справочник Пользователя для Netopia 4753 2a4na
6-4 Administration Guide
Launch your terminal emulation software and configure the communications software for the values shown in
the table below. These are the default communication parameters that the Netopia 4753 uses.
the table below. These are the default communication parameters that the Netopia 4753 uses.
Parameter
Suggested Value
Terminal type
PC: ANSI-BBS
Mac: ANSI, VT-100, or VT-200
Mac: ANSI, VT-100, or VT-200
Data bits
8
Parity
None
Stop bits
1
Speed
9600 bits per second (can be set for up to 57600)
Flow Control
None
Note: The router firmware contains an autobaud detection feature. If you are at any
screen on the serial console, you can change your baud rate and press Return
(HyperTerminal for the PC requires a disconnect). The new baud rate is displayed at
the bottom of the screen.
screen on the serial console, you can change your baud rate and press Return
(HyperTerminal for the PC requires a disconnect). The new baud rate is displayed at
the bottom of the screen.