Справочник Пользователя для Netopia 4753 2a4na

To configure your Wide Area Network (WAN) connection, navigate to the WAN Configuration screen from the Main 
Menu and select WAN Configuration, then WAN (Wide Area Network) Setup.

The DSL Line Configuration screen appears.

Each access concentrator (DSLAM) has a different set of defaults and other parameters.

Your ser vice provider should supply you with the appropriate information about the type and capabilities of the 
access concentrator equipment they use.

■

Select Regional Setting and from the pop-up menu select either Annex A or Annex B. Nor th American users 
select Annex A; non-Nor th American users select Annex B.

■

Select Clock Source and from the pop-up menu select either Network (the default) or Internal.

■

Select Cell Format and from the pop-up menu select either Scrambled (the default) or Unscrambled. This 
setting must match the format used by your ser vice provider. Scrambled is the most common, so you 
probably do not need to change it unless your provider specifically tells you to do so.

■

Select Unused Cell Format and from the pop-up menu select either Idle (the default) or Empty. This setting 
must match the format used by your ser vice provider. Idle is the most common, so you probably do not 

Main

Menu

WAN

Configuration

WAN

Setup

                            DSL Line Configuration

         Regional Setting...                Annex A

         Clock Source...                    Network
         Cell Format...                     Scrambled
         Unused Cell Format...              Idle

         Data Link Encapsulation...         RFC1483
         RFC1483 Mode...                    Bridged 1483
         PPP over Ethernet (PPPoE):         Off

         Display/Change Circuit...
         Add Circuit...
         Delete Circuit...