Справочник Пользователя для Netopia d3100-i

To connect the Netopia D-Series to your computer for serial console communication, use the supplied dual 
console cable connector end appropriate to your platform:

■

One DB-9 connector end attaches to a PC.

■

The mini-DIN8 connector end attaches to a Macintosh computer.

■

The DB-9 end of the Console cable attaches to the Netopia D-Series’s Console por t.

■

If you connect a PC with Microsoft Windows 95 or NT, you can use the HyperTerminal application bundled 
with the operating system.

■

If you connect a Macintosh computer, you can use the ZTerm terminal emulation program on the supplied 
CustomerCare CD.

Launch your terminal emulation software and configure the communications software for the values shown in 
the table below. These are the default communication parameters that the Netopia D-Series uses.

Features of the Netopia D-Series can be configured through the console screens via Telnet.

Before you can access the console screens through Telnet, you must have:

■

A network connection locally to the Netopia D-Series or IP access to the Netopia D-Series.

The default IP address of the Netopia D-Series is 192.168.1.1, subnet mask 255.255.255.0. In order to 
per form the initial configuration via Telnet your computer must have an IP address between 192.168.1.2 
and 192.168.1.254, subnet mask 255.255.255.0. 

Caution: If you change the Netopia D-Series’s IP address to some value outside of this range, you may lose 
contact with the unit via Telnet.

Parameter

Suggested Value

Terminal type

PC: ANSI-BBS
Mac: ANSI, VT-100, or VT-200

Data bits

8

Parity

None

Stop bits

1

Speed

57600 bits per second

Flow Control

None

Note: The Netopia D-Series firmware contains an autobaud detection feature. If you 
are at any screen on the serial console, you can change your baud rate and press 
Return (HyperTerminal for the PC requires a disconnect). The new baud rate is 
displayed at the bottom of the screen.