Справочное Руководство для Netopia r3100-u

To connect the Netopia R3100 to your computer for serial console communication, use the supplied dual 
console cable connector end appropriate to your platform:

■

one DE-9 connector end attaches to a PC

■

the mini-DIN8 connector end attaches to a Macintosh

■

the DE-9 end of the Console cable attaches to the Netopia R3100’s Console por t

If you are configuring your router via a terminal session, your computer must be running a standard terminal 
emulation or communications software program, such as those used with modems.

■

If you connect a PC with Microsoft Windows 95 or NT, you can use the HyperTerminal application bundled 
with the operating system.

■

If you connect a Macintosh computer, you can use the ZTerm terminal emulation program on the supplied 
Netopia R3100 CD.

Launch your terminal emulation software and configure the communications software for the following values. 
These are the default communication parameters that the Netopia R3100 uses.

Parameter

Suggested Value

Terminal type

PC: ANSI-BBS
Mac: ANSI, VT-100, or VT-200

Data bits

8

Parity

None

Stop bits

1

Speed

Options are: 9600, 19200, 38400, or 57600 bits per second

Flow Control

None

Note: The router firmware contains an autobaud detection feature. If you are at 
any screen on the serial console, you can change your baud rate and press 
Return (HyperTerminal for the PC requires a disconnect). The new baud rate is 
displayed at the bottom of the screen.