Справочное Руководство для Netopia r6100

Скачать
Страница из 352
Technical Specifications and Safety Information  E-5
FCC Requirements, Part 68. The Federal Communications Commission (FCC) has established Rules which 
permit this device to be directly connected to the telephone network. Standardized jacks are used for these 
connections. This equipment should not be used on par ty lines or coin phones.
If this device is malfunctioning, it may also be causing harm to the telephone network; this device should be 
disconnected until the source of the problem can be determined and until repair has been made. If this is not 
done, the telephone company may temporarily disconnect ser vice.
The telephone company may make changes in its technical operations and procedures; if such changes affect 
the compatibility or use of this device, the telephone company is required to give adequate notice of the 
changes. You will be advised of your right to file a complaint with the FCC.
If the telephone company requests information on what equipment is connected to their lines, inform them of:
a) The telephone number to which this unit is connected.
b) The ringer equivalence number 
c) The USOC jack required. (RJ11C)
d) The FCC Registration Number. (14 digits provided by FCC)
Items (b) and (d) are indicated on the label. The Ringer Equivalence Number (REN) is used to determine how 
many devices can be connected to your telephone line. In most areas, the sum of the REN's of all devices on 
any one line should not exceed five (5.0). If too many devices are attached, they many not ring properly.
Service requirements. In the event of equipment malfunction, all repairs should be per formed by our Company 
or an authorized agent. Under FCC rules, no customer is authorized to repair this equipment. This restriction 
applies regardless of whether the equipment is in or our of warranty. It is the responsibility of users requiring 
ser vice to repor t the need for ser vice to our Company or to one of our authorized agents. Ser vice can be 
obtained at Netopia, Inc., 2470 Mariner Square Loop, Alameda, California, 94501.
Important
This product was tested for FCC compliance under conditions that included the use of shielded cables and 
connectors between system components. Changes or modifications to this product not authorized by the 
manufacturer could void your authority to operate the equipment.
Canada. This digital apparatus does not exceed the Class B limits for radio noise emission from digital 
apparatus set out in the Radio Inter ference Regulations of the Canadian Depar tment of Communications.
Le présent appareil numérique n'émet pas de bruits radioélectriques dépassant les limites applicables aux 
appareils numériques de la classe A prescrites dans le Réglement sur le brouillage radioélectrique édicté par le 
ministère des Communications du Canada.
Declaration for Canadian users
The Canadian Industr y Canada label identifies cer tified equipment. This cer tification means that the equipment 
meets cer tain telecommunications network protective, operation, and safety requirements. The Depar tment 
does not guarantee the equipment will operate to the user’s satisfaction.
Before installing this equipment, users should ensure that it is permissible to be connected to the facilities of 
the local telecommunications company. The equipment must also be installed using an acceptable method of 
connection. In some cases, the company’s inside wiring associated with a single line individual ser vice may be 
extended by means of a cer tified connector assembly (telephone extension cord). The customer should be 
aware that compliance with the above conditions may not prevent degradation of ser vice in some situations.