Руководство Пользователя для Quantum DLT-S4
Chapter 14 Troubleshooting
POST and SCSI Troubleshooting
DLT-S4 Product Manual
124
3
Ensure that the connector on each end of the cable is fully seated.
4
Disconnect the tape drive from the host system, turn off the tape
drive, and turn it on again to perform a POST (see
5
If you have a SCSI tape drive—remove all devices from the SCSI bus.
Connect the tape drive directly to the host computer and terminate it
for internal tape drives or
tape drives).
Confirm that the tape drive and host computer are communicating
Confirm that the tape drive and host computer are communicating
properly before adding other devices.
6
If you have a Fibre Channel tape drive—look at the rear panel to see
if the Fibre Channel cable is correctly attached (see
If the link light is illuminated, you have a working connection with
the Fibre Channel network.
7
If you have a SAS tape drive -- look at the rear panel and make sure
the SAS cable is correctly attached (see
8
Ensure that the operating system (modules, patches, and drivers),
backup software, and tape drive are compatible. See
for the most current compatibility information.
If you cannot identify or correct the problem, contact customer support
on page xviii for contact information). Have the
model and serial number available when you call. You can find these
numbers on the bottom of the tabletop tape drive enclosure and on the
top of the internal and library tape drives.
POST and SCSI Troubleshooting
14
provides troubleshooting tips that you will find useful in the
event that the tape drive system fails its POST.