Инструкции По Установке для Quantum lto autoloader

 

Small flat-blade screwdriver 

 
 

 

ESD Sensitive Component. 
Please touch unit cover or rear panel before installing 
the barcode reader to avoid electrostatic discharge. 

 
 

1.  The barcode reader is to be mounted on the rear side of the autoloader. 

 

 
2.  Power down the autoloader 
3.  Remove the SCSI cable(s) and power cord from the rear panel of the autoloader and 

disconnect the power cord from the outlet. 

4.  Remove the cover plate from the rear panel and save the screws. Store the cover plate; 

you may use this plate later if you remove the barcode reader. 

5.  Orient the barcode reader in front of the slot. There is only one correct position. Check to 

make sure that the holes align. 

6.  Connect the cable to the barcode controller outlet. 
7.  Attach the barcode reader with the screws you saved. 
8.  Reconnect the SCSI cables and power cord to the autoloader. 

3