Руководство Пользователя для AASTRA cm16

 

Model CM-16 User Guide 7

 

From another M1 station, call this DN and answer the call by pressing the 
Handset Button (to the left of the 

 

∂

 

 button). Verify two way transmission 

and hang up by pressing the button to the right of the 

 

∂

 

 button. 

 

Refer to Figure 3.

1.

Plug the modular cord of the “cradle power adapter” into the jack on 
the bottom of the cradle. Route the cord through the retaining tabs of 
the molded cord slot. Verify the cradle rests on all four feet and 
doesn’t wobble.

2.

Plug the transformer into a known working non-switched AC outlet and 
place the handset, face up in the charging cradle. There is no power light 
on the cradle. However, once the handset is placed in the cradle, the 
battery icon will blink indicating the battery is being charged. Should the 
icon not blink, check the battery compartment cover to ensure it is properly 
closed. If the handset does not easily slide into the charging cradle, the 
battery compartment cover is likely not installed correctly.

 

To install the belt clip, snap one arm of the clip into the slot on the side of 
the handset and then slide the other arm into the slot on the other side of the 
handset until it snaps into place.

Non-switche

AC Outlet

Handset

(face down)

Keep the Battery

Near the handset

and don't connect 

it until Step 5

5

 Charger Preparation

 Handset Preparation