Руководство По Установке для TiVo Series2
45
5
T r o u b l e s h o o t i n g
If you have a cable or satellite box and used the IR Control cable:
• Make sure the cable or satellite box is turned on.
• Make sure you are using the DVR’s remote control, and that you hold it so that the
TiVo button points toward the DVR, not at the cable or satellite box.
• Refer to page 8 to verify that the IR Control cable is positioned correctly in front of the
IR sensor. Also, make sure that the purple end of the cable is plugged into the Control
Out-IR
Out-IR
connector on the back of the DVR.
• You may consider optimizing the IR Control connection as described on page 9.
• Press the TiVo button to go to TiVo Central, then select Messages & Setup, then
Cable/Satellite Box, then Control Cable Setup. Verify the IR code you chose during
Guided Setup. See page 8 for more on choosing an IR code.
Guided Setup. See page 8 for more on choosing an IR code.
• Try using the cable or satellite box’s remote to change the channel. If it doesn’t work,
contact the manufacturer or service provider for assistance.
If you have a Motorola/General Instruments DCT2000 series cable box or a DIRECTV
satellite box and used the Serial Control cable:
satellite box and used the Serial Control cable:
• Make sure the cable or satellite box is turned on.
• Verify that the Serial Control cable is plugged into the data connector on the cable or
satellite box and into the Control Out-Serial connector on the back of the DVR.
• Unplug the cable or satellite box’s power cord, then plug it back in. Make sure the
cable or satellite box is powered on. Then try changing channels with the TiVo remote
again.
again.
Serial control of a Motorola/
General Instruments DCT2000
series cable box may not be available for
all customers. Check with your cable
provider to find out if your cable box is
enabled for serial control. See page 7 for
more information about serial control.
®