Руководство Пользователя для Mobile Edge meap01

Carefully unpack your Card Presenter, and keep the packing materials for future reference. Check to
make sure that the following items are included:

•

Mobile Edge Wireless Remote Presenter (with USB receiver)

1

•

CR2032 lithium cell battery

1

•

User’s Manual

1

It is recommended to install this wireless presenter under one of the following Operating Systems

•

Windows¨ 98 SE, ME, 2000, XP

•

Mac¨ OS9.1 or later, Mac¨ OS X (10.1) or later

Note: Improper removal and insertion may damage the receiver, please follow the diagram below.

Step 1: Battery Storage - Open the battery cover and insert the battery. (Refer to Figure 1)

• Do not insert battery into the presenter in the wrong direction.
• Do not charge, heat, open, or short-circuit the battery.
• Do not leave dead or exhausted battery in the presenter.
• If the presenter will not be used for a long period of time, removing the battery will reduce the risk 

of damage due to battery corrosion.

• If the presenter does not function correctly or if the operating range is reduced replace the battery.

Step 2: Linking the Receiver - Remove the receiver and plug it into an available USB port on your
computer. (Refer to Figure 2) You may encounter the following conditions with different Operating
Systems:

• Windows¨ 98 SE/ME - The system may prompt you to insert the operating system CD-ROM and 

the follow the instruction to install the software required.

• Window¨ 2000/XP - The system identifies the receiver, prompts ”USB Human Interface Device” 

and begins installation automatically. Please follow the instructions on the screen to complete
the installation.

Note: It is recommended that you use the link option to make sure no other wireless products are
working at your same frequency, which may cause interference. Please follow these simple procedures.

a. Press the link key on the receiver (connected to your computer now), and the LED light on the 

receiver will come on. (Refer to Figure 1)

b. Press Fn button and the Link button on the Wireless Remote simultaneously for more than three 

seconds. The LED on the receiver will start flashing to confirm the link is complete. The Wireless 
Remote is now ready for use.

Note: Whenever you change new battery, it is recommended that you repeat the Link process again.

Using the Card Presenter
There are six buttons on the Card Presenter. The Fn button does not function except when used simul-
taneously with another key. The function of each button is described below.

Normal mode: Function of each button when not used with the Fn button.

Function mode: Function of each button when used with the Fn button. 
Note: The Fn button should always be pressed before depressing the other button.

Note: The laser button will automatically deactivate if it is idle for more than 30 minutes.

Laser

Activate the laser point first by pressing and holding the Fn & Laser buttons simultaneously 
over 3 seconds. (Warning: Never point the laser beam into human or pets eyes)

Next

Advance to the next page

Prev.

Return to the previous page

Right Arrow

In some modes - advance to next slide

Left Arrow

In some modes – return to previous slide

ESC

To exit slide show mode

Fn + On/Off

Switch the laser beam on or off

Fn + Black (dark circle)

Turn the projector beam to black screen

Fn + White (open circle)

Turn the projector beam to white screen

Fn + Link

Link the ID with the receiver