Руководство Пользователя для Sony ht-ddw780
60
GB
C:\Documents and
Settings\pc13\Desktop\J9052001_2662269111DDW780_GB\2662269111\GB06TUN_HT-
DDW780_CEL.fm
Settings\pc13\Desktop\J9052001_2662269111DDW780_GB\2662269111\GB06TUN_HT-
DDW780_CEL.fm
masterpage: Left
HT-DDW780
2-662-269-11 (1)
There is no picture or an unclear
picture appears on the TV screen or
monitor.
picture appears on the TV screen or
monitor.
• Select the appropriate input using the input
buttons.
• Set your TV to the appropriate input mode.
• Move your audio components away from
• Move your audio components away from
the TV.
• Assign the component video input
correctly.
Remote control
The remote does not function.
• Point the remote at the remote sensor on
the receiver.
• Remove any obstacles in the path between
the remote and the receiver.
• Replace all the batteries in the remote with
new ones, if they are weak.
• Make sure you select the correct input on
the remote.
* Models of area code CEL, CEK only.
Error messages
If there is a malfunction, the display shows a
message. You can check the condition of the
system by the message. Refer to the following
table to solve the problem. If any problem
persists, consult your nearest Sony dealer. If an
error message appears while you perform
Auto Calibration, see “Error and warning
codes” (page 27) to solve the problem.
message. You can check the condition of the
system by the message. Refer to the following
table to solve the problem. If any problem
persists, consult your nearest Sony dealer. If an
error message appears while you perform
Auto Calibration, see “Error and warning
codes” (page 27) to solve the problem.
DEC. EROR
Appears when a signal the receiver cannot
decode (ex. DTS-CD) is input and “DEC.
PRI.” on the AUDIO menu is set to “DEC.
PCM”. Set it to “DEC. AUTO” (page 35).
decode (ex. DTS-CD) is input and “DEC.
PRI.” on the AUDIO menu is set to “DEC.
PCM”. Set it to “DEC. AUTO” (page 35).
PROTECT
Irregular current is output from the
speakers. The receiver will automatically
turn off after a few seconds. Check the
speaker connection and turn on the power
again.
speakers. The receiver will automatically
turn off after a few seconds. Check the
speaker connection and turn on the power
again.
If you are unable to remedy the
problem using the
troubleshooting guide
problem using the
troubleshooting guide
Clearing the receiver’s memory may remedy
the problem (page 24). However, note that all
memorized settings will be reset to their
factory settings and you will have to readjust
all settings on the receiver.
the problem (page 24). However, note that all
memorized settings will be reset to their
factory settings and you will have to readjust
all settings on the receiver.
If the problem persist
Consult your nearest Sony dealer. Note that if
service personnel changes some parts during
repair, these parts may be retained.
service personnel changes some parts during
repair, these parts may be retained.
Reference sections for clearing
the receiver’s memory
the receiver’s memory
To clear
See
All memorized settings
page 24
Customized sound fields
page 45
GB01COV_HT-DDW780_CEL.book Page 60 Friday, January 20, 2006 11:32 AM