Руководство Пользователя для Zhone 1740 shdsl
1740 SHDSL 2/4-Wire Router User’s Guide
CHAPTER 17 Console Access
To access the device via the console port the following are required:
z
VT100 Compatible Terminal
This terminal is essential to perform the initial configuration of the router. This is normally a terminal with a
VT100 emulation program, such as Telix or HyperTerminal Edition 5.
VT100 emulation program, such as Telix or HyperTerminal Edition 5.
z
Console Port Cable
An RS-232, DB9-to-DB9 straight-through cable is only required if you need to connect the device to a
VT100 terminal or equivalent. The cable is not supplied with the SHDSL router.
VT100 terminal or equivalent. The cable is not supplied with the SHDSL router.
17.1 Login
For access by console, the console PC should be installed with a standard VT100 emulation program,
such as HyperTerminal 5 or Telix. You must connect the router to a PC using a serial cable. The following
steps describe how to establish the console session.
such as HyperTerminal 5 or Telix. You must connect the router to a PC using a serial cable. The following
steps describe how to establish the console session.
STEP1: Run a standard VT100 program such as HyperTerminal (Ver. 5 is recommended), or Telix in the
local terminal and select an open com port.
STEP2: Enter the following port settings:
z
Baud rate: 9600
z
Data bits: 8
z
Parity: none
z
Stop bit: 1
z
Flow control: none
STEP3: After the session parameters are set up, press the Enter Key. You will be requested to enter the
user name and password.
STEP4: After successfully logging in, the main menu will appear.
1740-A2-GB20-20 May 2005
79