Справочник Пользователя для ZyXEL p-2302hw-p1

P-2302HW/HWL-P1 Series User’s Guide

Chapter 16 Static Route

203

Figure 112   Management > Static Route > IP Static Route > Edit

Each field is described in the following table.

Table 84   Management > Static Route > IP Static Route > Edit

Route Name

Enter the name of the static route.

Active

Select this if you want the static route to be used. Clear this if you do not want the 
static route to be used.

Private

Select this if you do not want the ZyXEL Device to tell other routers about this 
static route. For example, you might select this if the static route is in your LAN. 
Clear this if you want the ZyXEL Device to tell other routers about this static route.

Destination IP 
Address

Enter one of the destination IP addresses that this static route affects.

IP Subnet Mask

Enter the subnet mask that defines the range of destination IP addresses that this 
static route affects. If this static route affects only one IP address, enter 
255.255.255.255.

Gateway IP 
Address

Enter the IP address of the gateway to which the ZyXEL Device should send 
packets for the specified Destination. The gateway is a router or a switch on the 
same network segment as the device's LAN or WAN port. The gateway helps 
forward packets to their destinations.

Metric

Usually, you should keep the default value. This field is related to RIP. See 

 for more information.

The metric represents the "cost of transmission". A router determines the best 
route for transmission by choosing a path with the lowest "cost". The smaller the 
metric, the lower the "cost". RIP uses hop count as the measurement of cost, 
where 1 is for a directly-connected network. The metric must be 1-15; if you use a 
value higher than 15, the routers assume the link is down.

Apply

Click this to save your changes and to apply them to the ZyXEL Device.

Cancel

Click this to return to the previous screen without saving your changes.