Руководство Пользователя для Jet jdp-17mf drill press
12
12. Install three down feed handles (B, Figure 4)
into the down feed hub (C, Figure 4).
13. Thoroughly clean spindle, arbor and chuck
(A/B/C, Figure 5). Important: These three
pieces must be free of any rust protectant,
or lubricant. If they are not clean, the arbor
and chuck will fail to seat in the spindle.
pieces must be free of any rust protectant,
or lubricant. If they are not clean, the arbor
and chuck will fail to seat in the spindle.
14. Turn the arbor until the tang on the arbor
engages the slot at the end of the spindle.
Slide arbor up into spindle.
Slide arbor up into spindle.
15. Firmly push chuck by hand onto taper of
arbor.
16. Make sure chuck jaws are opened all the
way until they are inside chuck body. Use a
few taps from a rubber mallet, or a hammer
and a block of wood, against the bottom of
the chuck to seat the chuck securely onto
the arbor. Do not use a steel-faced
hammer directly against the chuck.
few taps from a rubber mallet, or a hammer
and a block of wood, against the bottom of
the chuck to seat the chuck securely onto
the arbor. Do not use a steel-faced
hammer directly against the chuck.
Removing the Chuck and Arbor
1. Unplug machine from the power source.
2. Raise the table until it is about seven inchs
below the chuck.
3. Place a piece of scrap wood on the table,
and lower quill using the down feed handle.
4. Rotate spindle to align the key hole in the
spindle with the key hole in the quill.
5. Insert the drift key (D, Figure 6) into the
aligned slots and tap lightly. The chuck and
arbor assembly should fall from the spindle.
arbor assembly should fall from the spindle.
Figure 4
Figure 5
Figure 6