Руководство Пользователя для Jet jwbs-18qt
22
Pulley Alignment
The pulley alignment is done in conjunction with the
poly V-belt replacement.
poly V-belt replacement.
If you are just beginning the alignment, start with
the Replacing the Poly V-Belt section (previous
page.
the Replacing the Poly V-Belt section (previous
page.
If you were directed here, proceed as follows:
1. Uses a straight edge placed against the wheel
pulley and motor pulley and refer to Figure 29
to determine if alignment is necessary.
to determine if alignment is necessary.
If alignment is necessary:
2. With a 4mm hex wrench, loosen two set screws
on the motor (lower) pulley.
3. Adjust the motor pulley by sliding in or out.
4. Confirm the alignment of the poly V-belt by
placing a straight edge against the faces of
both pulleys, (Figure 29). If the straight edge
lies flush against both pulleys, then the pulleys
and belt are aligned.
both pulleys, (Figure 29). If the straight edge
lies flush against both pulleys, then the pulleys
and belt are aligned.
5. Re-tighten the two set screws on the motor
pulley.
Return to Step 7 of the Replacing Poly V-Belt
section on page 21.
section on page 21.
Figure 29