Справочник Пользователя для Jet dc-1100a

 

9

1. Install 

four casters to the under side of the base as 

pictured in Fig. 2. 

2.  Thread the hex nut (B, Fig. 1) onto the caster 

shaft.  Then slide the lock washer (A, Fig. 1) over 
the caster shaft.  Thread the caster shaft into the 
threaded hole on the underside of the base, turn 
until snug.  Tighten the nut (B, Fig. 1) against the 
base with a 14mm wrench.  This will give the 
caster proper clearance. 

 

 

 

3.  Place the base with casters on the ground.  Attach 

the motor and fan assembly (A, Fig. 2) to the base 
using four M8 x 16 hex cap screws, four M8 flat 
washers (B, Fig. 2), and a 13mm wrench. 

 

 

 

connected to the power source during assembly.  
Failure to comply may result in serious injury! 

 

 

 

 

4.  Attach inlet guard (A, Fig. 3) to fan housing using 

eight M

6 x 12 pan head screws (B, Fig. 3).  Press 

the inlet ports (C, Fig. 3) onto the inlet guard until it 
snaps into place.