Справочник Пользователя для Jet dc-1100a

 

10

5.  Attach three support brackets (A, Fig. 4) to the 

base using six M8 x 16 hex cap bolts and six M8 
flat washers (B, Fig. 4).  Hand-tighten only at this 
time. 

 

 

 

 

 

 

 

6.  Install the housing (A, Fig. 5) to two support 

brackets (B, Fig. 5) using four M8 x 16 hex cap 
bolts, eight M8 flat washers, and four M8 hex nuts 
(C, Fig. 5).  Be sure hose opening faces fan 
housing.   

7.  Before attaching third support bracket place the 

hanger bracket (D, Fig.5) between the support 
bracket and the housing. 

Note: The hanger bracket is used in models 
DC-1100A/RC only. 

8.  Tighten all nuts and bolts at this time with a 13mm 

wrench. 

 

 

 

 

9.  Attach the hose (A, Fig. 6) between the fan 

housing and the collector housing with two clamps 
(B, Fig. 6).  Tighten the clamps to secure the hose.  

 

 

 

If you are assembling the DC-1100A/RC Dust 
Collector, proceed to the next section. If you are 
assembling the DC-1100C/RC Dust Collector, proceed 
to Collector Bag Installation – DC-1100C/RC section.