Руководство Пользователя для Maytag mhwe200x

WARNING

IMPORTANT: Position the washer so that the rear of the washer is 

within approximately 3 ft. (900 mm) of its final location.
There are 4 transport bolts in the rear panel of the washer that 

support the suspension system during transportation. These bolts 

also retain the power cord inside the washer until the bolts are 

removed. 

1. On the back of the washer, loosen the 4 transport bolts using a 

13 mm wrench.

2. Once the bolt is loose, move it to the center of the hole and 

completely pull out the bolt, including the plastic spacer 

covering the bolt. 

3. Once all 4 bolts are removed, discard the bolts and spacers. 

Then pull the power cord through the opening of the rear panel 

and close the hole with the attached cap.

4. Cover the bolt holes with the 4 transport bolt hole plugs.
NOTE: If the washer is to be transported at a later date, call your 

local service center. To avoid suspension and structural damage, 

your machine must be properly set up for relocation by a certified 

technician.

Insert new flat washers (supplied) into each end of the inlet hoses. 

Firmly seat the washers in the couplings. 

Make sure washer drum is empty and flat washers have been placed 

into hose couplings. Both hoses must be used for the washer to 

work properly.
1. Attach a hose to the hot water faucet. Screw on coupling by 

hand until it is seated on the washer. 

2. Attach a hose to the cold water faucet. Screw on coupling by 

hand until it is seated on the washer.

3. Using pliers, tighten the couplings with an additional  

two-thirds turn. 

NOTE: Do not overtighten. Damage to the coupling or water faucet 

can result. Both faucets must be turned on for the washer to work 

properly.

■

Run water through both faucets and inlet hoses, into a laundry 

tub, drainpipe or bucket, to get rid of particles in the water lines 

that might clog the inlet valve screens.

■

Check the temperature of the water to make sure that the hot 

water hose is connected to the hot water faucet and that the cold 

water hose is connected to the cold water faucet.