Руководство Пользователя для Maytag mhwe300v

If using liquid chlorine bleach: 
Open the dispenser drawer and immediately add 

2

/

3

 cup (160 mL) of liquid chlorine 

bleach to the bleach compartment.

NOTE: Do not add any detergent to this cycle. Use of more than 

2

/

3

 cup (160 mL)  

of bleach will cause product damage over time.

3. Close the washer door and dispenser drawer.
4. Select the Clean Washer cycle.
5. Press START/PAUSE.

NOTE: The basket will rotate, then the door will unlock, lock again, and then the cycle 
will continue.

„

The machine will bring in some inlet water, and the basket will rotate while the 
washer runs a short sensing cycle. This will take approximately 3 minutes.

6. The cycle will determine whether clothing or other items are in the washer.  

a) 

If no items are detected in the washer, it will proceed to 
Step 7.
If any items are detected in the washer, “rL” will be 
displayed, and the WASH and CONTROLS LOCK lights 
will remain lit. The door will unlock. Open and remove any 
garments in the wash drum.

„

Press POWER/CANCEL to cancel the failure code. Then 
repeat steps 3, 4, and 5 to start the cycle again.

7. Once the cycle has begun, allow the cycle to complete. 
8. After the cycle is complete, leave the door open slightly to allow for better ventilation and 

drying of the washer interior.

„

Use only HE High Efficiency detergent.

„

Leave the door slightly open after each cycle to allow for better ventilation and drying  
of washer interior.

„

Repeat the cleaning procedure monthly or when the CLEAN WASHER REMINDER light 
illuminates.

„

If you are not ready to run the Clean Washer cycle, but the Clean Washer Reminder light 
is illuminated, press the Clean Washer Reset button.

If the procedure does not sufficiently improve the machine freshness, evaluate your 

installation and usage conditions for other causes.

The dispenser drawer is removable for easy cleaning.
1. Open the dispenser drawer. Unlock the dispenser drawer by pressing the Release Lever  

on the left side of the dispenser drawer. See “Using the Dispenser”. Remove the drawer.

2. Wash the dispenser under running water to clean. Allow to dry.
3. Return the dispenser to drawer.

Use a soft damp cloth or sponge to wipe up any spills. Occasionally wipe the outside of your 
washer to keep it looking new. Use mild soap and water. Do not use abrasive products.

Replace inlet hoses after 5 years of use to reduce the risk of hose failure. Periodically inspect 
and replace inlet hoses if bulges, kinks, cuts, wear, or leaks are found. 
When replacing your inlet hoses, record the date of replacement. 

Install and store your washer where it will not freeze. Because some water may stay in the 
hoses, freezing can damage your washer. If storing or moving your washer during freezing 
weather, winterize it.

Operate your washer only when you are at home. If you will be on vacation or not using  
your washer for an extended period of time, you should:

„

Unplug washer or disconnect power.

„

Turn off the water supply to the washer. This helps avoid unintended flooding (due to a 
water pressure surge) while you are away.

„

Slightly open door to provide ventilation.

1. Put 1 qt (1 L) of R.V.-type antifreeze in the drum.
2. Run washer on a Drain & Spin cycle.
3. Unplug washer or disconnect power.
4. Shut off both water faucets.
5. Disconnect water inlet hoses from faucets and drain.

1. Flush water pipes. Reconnect water inlet hoses to faucets. Turn on both water faucets. 

Electrical Shock Hazard

Plug into a grounded 3 prong outlet.

Do not remove ground prong.

Do not use an adapter.

Do not use an extension cord.

Failure to follow these instructions can result in death, 
fire, or electrical shock.

WARNING

2. Plug in washer or reconnect power.