Руководство Пользователя для Maytag mhwe300v

Selecting the proper location for your washer improves performance and minimizes noise and 
possible washer “walk.”
Your washer can be installed under a custom counter, or in a basement, laundry room, closet, 
or recessed area. See “Drain System.”
Companion appliance location requirements should also be considered. Proper installation is 
your responsibility.
You will need

„

A water heater set to deliver 120°F (49°C) water to the washer.

„

A grounded electrical outlet located within 6 ft (1.8 m) of where the power cord is 
attached to the back of the washer. See “Electrical Requirements.”

„

Hot and cold water faucets located within 4 ft (1.2 m) of the hot and cold water fill valves, 
and water pressure of 20-100 psi (137.9-689.6 kPa).

„

A level floor with a maximum slope of 1" (25 mm) under entire washer. Installing the 
washer on soft floor surfaces, such as carpets or surfaces with foam backing, is not 
recommended.

„

A sturdy and solid floor to support the washer with a total weight (water and load) of 
400 lbs (180 kg).

Do not operate your washer in temperatures below 32°F (0°C). Some water can remain in the 
washer and can cause damage in low temperatures.

„

The location must be large enough to allow the washer door to be fully opened.

„

Additional spacing should be considered for ease of installation and servicing.

„

Additional clearances might be required for wall, door, and floor moldings.

„

Additional spacing of 1" (25 mm) on all sides of the washer is recommended to reduce 
noise transfer.

„

Companion appliance spacing should also be considered.

27"

(686 mm)

51"

(1295 mm)

38"

(965 mm)

31½"

(800 mm)

The dimensions shown are for the recommended spacing.
Custom undercounter installation - Washer only 

1"

(25 mm)

1"

(25 mm)

39" min.

(990 mm)

27"

(686 mm)