Справочник Пользователя для iRobot 1100

www.irobot.com

Remove and empty

Dirt Dog’s bin

Clean Dirt Dog’s cliff detect

sensors (use compressed air)

Clean Dirt Dog’s brushes

A. Remove brush guard by pulling

both yellow tabs

Maintenance

To keep Dirt Dog running at peak performance, it is recommended that you
perform the following maintenance tasks every three uses:

Press button and

pull to remove bin

B. Remove and clean Dirt Dog’s

brushes. Remove brush caps and

use scissors to cut any hair wrapped

around the brush. Use the Dirt Dog

cleaning tool to comb hair from brush.

C. Remove and clean hair and dirt from

Dirt Dog’s brush bearings.

TIP: Bin emptying and brush cleaning should be done after every 3- cleaning

cycles depending on the amount of hair, dirt, and debris in your environment.

TIP: If you notice Dirt Dog picking up less debris from your floor, empty the bin

and clean the brushes.

Do not attempt to run Dirt Dog without the bearings. If you misplace Dirt

Dog’s brush bearings, contact iRobot Customer Care for replacement
bearings.

Excessive build up of hair in Dirt Dog’s brushes and bearings can

permanently damage Dirt Dog. Inspect brush bearings regularly.

Brush

bearings

Brushes

Brush

caps

Visit www.irobot.com/usetips

for instructional photos

Sensors