Инструкция С Настройками для Integra dpc-5.3
17
Connecting the Power
The DPC-5.3 is shipped with the main power (Power) switch in the on
position (
position (
_ On). When the power cord is plugged in for the first time,
the DPC-5.3 will automatically enter the Standby mode and the
Standby indicator will blink for about 10 seconds, then light (same
condition after step 2 below). While the Standby indicator is blinking,
operation buttons will not function.
Standby indicator will blink for about 10 seconds, then light (same
condition after step 2 below). While the Standby indicator is blinking,
operation buttons will not function.
Turning on
2
Press Power to switch on the main
power.
power.
The DVD Changer enters standby mode.
The Standby indicator blinks for about 10 seconds,
then lights. While the Standby indicator is blinking,
operation buttons will not function.
The Standby indicator blinks for about 10 seconds,
then lights. While the Standby indicator is blinking,
operation buttons will not function.
Notes
• The buttons on the remote controller do not operate if the
Power switch is set to Off.
• To switch off the main power, press Power again.
Notes
• Make sure that all appropriate connections have been completed as
described on pages 14 to 16.
• Turning on the DVD Changer may cause a momentary power
surge, which might interfere with other electrical equipment such
as computers. To prevent interference, use a wall outlet on a
different circuit.
as computers. To prevent interference, use a wall outlet on a
different circuit.
DISC SKIP
STANDBY/ON
DPC-5.3
Power
Standby/On
Standby indicator
1
Plug the supplied power cord into the
AC INLET and then into the power outlet
on the wall.
on the wall.
Notes
• Do not use a power cord other than the one supplied with
the DPC-5.3. The power cord supplied is designed for
use with the DPC-5.3 and should not be used with any
other device.
use with the DPC-5.3 and should not be used with any
other device.
• Never have the power cord disconnected from the
DPC-5.3 while the other end is plugged into the wall
outlet. Doing so may cause an electric shock. Always
connect by plugging into the wall outlet last and
disconnect by unplugging from the wall outlet first.
outlet. Doing so may cause an electric shock. Always
connect by plugging into the wall outlet last and
disconnect by unplugging from the wall outlet first.
3
Press Standby/On on the DVD
Changer or remote controller.
Changer or remote controller.
The DVD Changer turns on and the Standby
indicator turns off. It takes several seconds to read
the disc in the disc tray.
indicator turns off. It takes several seconds to read
the disc in the disc tray.
Notes
• You can turn on the DVD Changer by pressing Open/
Close or Play.
• To put the DVD Changer in the standby mode, press
Standby/On on the DVD Changer or remote
controller. Be sure to set the volume to minimum before
putting the DVD Changer in the standby mode for the
next use to avoid sudden loud sound reproduction.
putting the DVD Changer in the standby mode for the
next use to avoid sudden loud sound reproduction.
• While the Standby indicator lights up, the DVD
Changer can receive signals from the remote controller.
However, if you press Power on the DVD Changer to
switch off the main power, the remote controller cannot
be used to turn on the DVD Changer.
However, if you press Power on the DVD Changer to
switch off the main power, the remote controller cannot
be used to turn on the DVD Changer.
• Setting the Standby button to standby does not shut off
the power completely.
AC INLET
To a wall outlet
Power cord (supplied)