Инструкция С Настройками для Integra dpc-5.3
37
Operating Components not Reached by the
Remote Controller Signals (IR IN/OUT)
Remote Controller Signals (IR IN/OUT)
The following equipment (sold separately) is essential for operation:
• Onkyo’s Multi-Room System kits (IR Remote Controller Extension System), or
• Multiroom A/V distribution and control systems from Niles
• Multiroom A/V distribution and control systems from Niles
®
and Xantech
®
to name a few.
If the remote controller signal does
not reach the DPC-5.3 remote sensor
not reach the DPC-5.3 remote sensor
If the remote controller signal does not
reach other components
reach other components
If the DPC-5.3 is located inside a cabinet or other enclosure where
the infrared rays from the remote controller cannot enter, then
operation with the remote controller will not be possible. In such a
case, it will be necessary to install a remote sensor at a location
outside of the cabinet for the infrared rays from the controller to
reach.
the infrared rays from the remote controller cannot enter, then
operation with the remote controller will not be possible. In such a
case, it will be necessary to install a remote sensor at a location
outside of the cabinet for the infrared rays from the controller to
reach.
In this situation, you will need to use a commercially-available IR
emitter. Connect the mini plug of the IR emitter to the IR OUT
terminal on the DPC-5.3. Then place the IR emitter on the remote
sensor of the component or facing it. When the IR emitter is
connected, only the signal input to the IR IN terminal is output to
the IR OUT terminal. The signal input from the remote sensor on
the front of the DPC-5.3 will not be output to the IR OUT
terminal.
emitter. Connect the mini plug of the IR emitter to the IR OUT
terminal on the DPC-5.3. Then place the IR emitter on the remote
sensor of the component or facing it. When the IR emitter is
connected, only the signal input to the IR IN terminal is output to
the IR OUT terminal. The signal input from the remote sensor on
the front of the DPC-5.3 will not be output to the IR OUT
terminal.
DPC-5.3
OUT
IN
IR
Make connection as shown below. Do not plug the equipment into
the power source until the connection is completed.
the power source until the connection is completed.
IR IN
DPC-5.3
In the
cabinet
cabinet
Remote Controller
Connecting
block
block
IR Receiver
: Signal flow
IR IN
IR OUT
Connecting
block
block
IR Receiver
DPC-5.3
IR Emitter
Remote Controller
other
component
component
: Signal flow
Remote control
sensor
sensor
DPC-5.3
OUT
IN
IR
from connecting block
Mini plug cable
from connecting block
Mini plug cable
Mini plug
Emitter
Mini plug cable
IR Emitter
:Signal flow