Руководство Пользователя для Inter-m l-1400
5
L800/1400/1800/2400
Front Panel
Front Panel
1. HANDLES
These are provided for easy transporting and installing into equipment enclosures or racks.
2. LEVEL CONTROL
This control adjusts the level (amplitude) of the input signal for each channel. In stereo or parallel mode
the knobs will determine the signal level independently for each channel. In the bridge mono mode
channel 1 will be turned fully to the right and channel 2 will be turned right only as needed to achieve
the desired signal level.
the knobs will determine the signal level independently for each channel. In the bridge mono mode
channel 1 will be turned fully to the right and channel 2 will be turned right only as needed to achieve
the desired signal level.
3. LEVEL INDICATOR
These indicators should illuminate during normal operation when there is an output signal.
4. CLIP LIMITER INDICATOR
This warns of a problem when illuminated. Reduce the LEVEL of the device which supplies signal to the
amplifier or reduce the LEVEL control(s) on the amplifier. This should not be continuously illuminated dur-
ing normal operation, but may flash occasionally.
amplifier or reduce the LEVEL control(s) on the amplifier. This should not be continuously illuminated dur-
ing normal operation, but may flash occasionally.
5. PROTECTION INDICATOR
This warns of a problem in the system when illuminated. Reduce the volume and look for problems. It is
possible that the amplifier is too hot or the speaker impedance is too low. This should not be illuminated
during normal operation.
possible that the amplifier is too hot or the speaker impedance is too low. This should not be illuminated
during normal operation.
6. MODE INDICATOR
This indicates the operating mode based on the position of the MODE selector switch located on the rear
panel.
panel.
7. POWER INDICATOR
This confirms the amplifier is switched ON and receiving AC mains POWER when illuminated.
8. POWER SWITCH
The position of this switch determines whether the AC mains power is ON or OFF. The power-on status
is confirmed by the illuminated power indicator. Amplifiers are always the last item in a system to be
turned on. It is generally a good idea to reduce the level controls before applying AC mains power.
is confirmed by the illuminated power indicator. Amplifiers are always the last item in a system to be
turned on. It is generally a good idea to reduce the level controls before applying AC mains power.
PROFESSIONAL POWER AMPLIFIER
PA
RA
LLE
L
POWER
ST
ER
EO
BR
ID
GE
D
MODE
PROT
30
10
CLIP/LIM
30
10
CLIP/LIM PROT
19
17
22
13
10
0
1
2
29
54
15
11
12
9
8
7
5
4
3
6
19
17
22
13
10
0
1
2
29
54
15
11
12
9
8
7
5
4
3
6
POWER
OFF
ON
1
2
3
4 5
6
7
8
PROFESSIONAL POWER AMPLIFIER
2400