Руководство Пользователя для Ingersoll-Rand 308 air die grinder

WARNING LABEL IDENTIFICATION

FAILURE TO OBSERVE THE FOLLOWING WARNINGS COULD RESULT IN INJURY.

Always wear eye protection

when operating or perform-

ing maintenance on this tool.

WARNING

Always wear hearing

protection when operating

this tool.

Always turn off the air sup-

ply and disconnect the air

supply hose before install-

ing, removing or adjusting

any accessory on this tool,

or before performing any

maintenance on this tool.

WARNING

Air powered tools can vibrate

in use. Vibration, repetitive

motions or uncomfortable po-

sitions may be harmful to your

hands and arms. Stop using

any tool if discomfort, tingling

feeling or pain occurs. Seek

medical advice before resum-

ing use.

WARNING

Do not carry the tool by the

hose.

WARNING

Do not use damaged, frayed

or deteriorated air hoses

and fittings.

WARNING

Keep body stance balanced

and firm. Do not overreach

when operating this tool.

WARNING

Operate at 90 psig (6.2 bar/

620 kPa) Maximum air pres-

sure.

90 psig

(6.2bar/620kPa)

International Warning Label:

Order Part No. ___________

USING THE TOOL (Continued)

•

When starting with a cold wheel, apply it to the work

slowly until the wheel gradually warms up. Make

smooth contact with the work and avoid any bumping

action or excessive pressure.

•

Models 308 and 308--EU Die Grinders have a free

speed of 25 000 rpm when operated at 90 psig

(6.2 bar/620 kPa) air pressure. Operation at higher

air pressure will result in excessive speed.

•

Always match collet size with accessory shank size.

•

Always insert tool shank no less than 10 mm in the

collet. Tighten Collet Nut securely to prevent

accessory from working out during operation of the

Grinder. Check tightness of Collet Nut before

operating the Grinder. Pay particular attention to the

fact that allowed speed of a mounted point is lowered

when the length of the shaft is increased between end

of collet and mounted point (overhang).

PLACING TOOL IN SERVICE

LUBRICATION

Ingersoll--Rand No. 50

Ingersoll--Rand No. 67

Always use of an air line lubricator with these tools.
We recommend the following Filter--Lubricator--Regulator
Unit:

For International -- No. C18--C3--FKG0

For USA -- No. C18--03--FKG0--28

After each two hours of operation, if an air line
lubricator is not used, inject 1/2 to 1 cc of Ingersoll--Rand
No. 10 Oil into the Air Inlet.

MAIN LINES 3 TIMES

AIR TOOL INLET SIZE

AIR

SYSTEM

AIR

TOOL

LUBRICATOR

REGULATOR

FILTER

BRANCH LINE 2 TIMES

AIR TOOL INLET SIZE

DRAIN REGULARLY

COMPRESSOR

(Dwg. TPD905--1)

SPECIFICATIONS

Model

Collet

Speed/rpm

Sound Level

dB (A)

♦Vibrations Level

Pressure

•Power

m/s

308, 308--EU

1/4”

25,000

95.1

108.1

2.6

Tested in accordance with ANSI S5.1--1971 at free speed

♦ Tested in accordance with ISO8662--1 with artificial unbalanced load at 50% of rated speed for ungoverned tools and at

80% rated free speed for governed tools.

•

ISO3744