Руководство Пользователя для Viewsonic PJL6243

12

ViewSonic PJL6243

12

Adjustable Foot

Foot Lock Latch

Projection angle can be adjusted up to 10.0 

degrees with the adjustable foot. 

Lift the front of the projector and push the foot 

lock latch on the projector.

Release the foot lock latch to lock the adjustable 

foot and rotate the adjustable foot to adjust the 

position and tilt.

To retract the adjustable foot, lift the front of the projector 

and push and undo the foot lock latch. Keystone 

distortion of the projected image can be corrected 

by menu operation. (see pages 23, 35, 43, 45)

To ensure safe operation, please observe the following precautions :

  ● Use two (2) AAA or LR03 type alkaline batteries.

  ● Always replace batteries in sets.

  ● Do not use a new battery with a used battery.

  ● Avoid contact with water or liquid.

  ● Do not expose the remote control to moisture or heat.

  ● Do not drop the remote control.

  ● If the battery has leaked on the remote control, carefully wipe the case clean and install new batteries.

  ● Risk of an explosion if battery is replaced by an incorrect type. 

  ● Dispose of used batteries according to the instructions or your local disposal rule or guidelines.

Open the battery 

compartment lid.

Install new batteries 

into the compartment.

Replace the 

compartment lid.

For correct polarity (+ 

and –), be sure battery 

terminals are in contact 

with pins in compartment.

Point the remote control toward the projector 

(Infrared Remote Receiver) when pressing the 

buttons. Maximum operating range for the remote 

control is about 16.4'(5 m) and 60 degrees in front 

of the projector.

16.4'

(5 m)

30° Remote control

30°

The 2 different remote control codes (Code 1–Code 

2) are assigned to this projector. Switching the remote 

control codes prevents interference from other remote 

controls when several projectors or video equipment 

next to each other are operated at the same time. 

Change the remote control code for the projector 

first before changing that for the remote control. See 

"Remote control" in the Setting Menu on page 52.

Press and hold the MENU and IMAGE buttons for 

more than five seconds to switch between the 

1 and Code 2. The initial code is set to Code 1.