Инструкция Товара для GoVideo vr2940
34
6 - Advanced Settings (cont.)
Scan Mode
Enables or disables Progressive Scan.
• Do NOT enable Progressive Scan
unless you have connected the DVD
Recorder+VCR to a TV equipped with
Progressive Scan inputs.
• If you do accidentally select Progressive
Scan and your screen goes black, press
and hold the P.SCAN button on the remote
control for 3 seconds to resume normal
operation.
1
Press
SETUP.
2
Use
/
to select “Preferences.”
3
Use
/
to select “Video,” then press
ENTER.
4
Use
/
to select “Scan Mode,” then
press
ENTER.
5
Use
/
to select your preferred Scan
Mode, then press
ENTER.
•
Interlace - Choose when using a
standard video, S-Video, or Component
video connection to your TV.
•
Progressive - Choose when using a
Progressive Scan connection to your TV.
6
Press
SETUP to exit.
Audio Settings
Digital Output
Sets the format of the signal from the Coaxial
Digital Audio Out jack. This jack is used to
output the audio signal recorded on DVD discs
to an external digital amplifier/receiver.
1
Press
SETUP.
2
Use
/
to select “Preferences.”
3
Use
/
to select “Audio,” then press
ENTER.
4
Use
/
to select “Digital Output,” then
press
ENTER.
5
Use
/
to select your preferred digital
audio output signal, then press
ENTER.
•
Off - Select if you are not using the
digital audio output.
•
Bitstream - Select if the DVD
Recorder+VCR is connected to a 5.1
channel amplifier/receiver with a Dolby
Digital decoder.
•
LPCM - Select if the DVD
Recorder+VCR is connected to a 2
channel digital amplifier.
6
Press
SETUP to exit.
Dynamic Range
Compresses the dynamic range of the audio
output (the difference between the loudest
and quietest passages) while watching DVD
movies. This allows you to listen to a movie at
a lower volume without losing sound clarity.
1
Press
SETUP.
2
Use
/
to select “Preferences.”
3
Use
/
to select “Audio,” then press
ENTER.
4
Use
/
to select “Dynamic Range,” then
press
ENTER.
5
Use
/
to set the Dynamic Range to
Off, Low (minimal compression), or High
(maximum compression), then press
ENTER.
6
Press
SETUP to exit.
Virtual Surround
Creates a simulated 3D effect from two
speakers.
1
Press
SETUP.
2
Use
/
to select “Preferences.”
3
Use
/
to select “Audio,” then press
ENTER.
4
Use
/
to select “Virtual Surround,” then
press
ENTER.
5
Use
/
to turn Virtual Surround on or off,
then press
ENTER.
6
Press
SETUP to exit.
Audio
Digital Output
Off
Dynamic Range
Off
Virtual Surround
Off
VCR Reception
Stereo
Tape Play Back
Hi-Fi
Instructions
Enter-Confirm Setup-Exit Move
…†