Инструкции Пользователя для Audiovox av-3000

-2-

maximum signal to the receiver.  When in an extremely
strong (local) signal area, set the switch to the Local
setting (“out” position).  This will eliminate weak signals
and suppress overly strong signals so as to avoid
overloading the receiver input.  When moving out of the
strong signal area, return the switch to the Distant (in)
setting.

NOTE: The Local/Distant Selector only affects FM sig-

nals, and will have no effect on AM reception.

9

Hold the cassette with the exposed tape edge to the right
and insert it into the cassette door.  Depress fully until the
cassette is engaged and begins playing.

NOTE: Observe the cassette operation cautions in the

Care and Maintenance section of this manual.

bl

This button performs two functions.  To eject a cassette,
simply depress the button fully then release.  The
cassette will eject and radio operation will resume.

To fast-forward the tape, depress the button half-way in
to the locked position. To stop fast-forward and resume
normal tape playback, depress the button slightly and
release.  Do not press fully in or the cassette will be
ejected.

NOTE: Never leave a cassette engaged in the player

when not in use.  Doing so can cause damage to
the cassette and/or mechanism of the unit.  Al-
ways press the eject button and remove the
cassette when leaving the vehicle.

is off frequency, you could experience noise and recep-
tion problems.  The dial pointer will move along the dial
to indicate the frequency to which you are tuned.

6

This indicator will illuminate during reception of FM
stereo broadcasts.  If the indicator flickers or goes on
and off as you drive, it is an indication that the stereo
signal is too weak to reproduce clearly and you should
select another station.

7

It is very important to adjust the Antenna Trimmer for
optimum AM reception.  The antenna trimmer is located
at the back of the tape slot.  Adjust it as follows:
1. Tune in a weak station around 1400 KHz on the AM

band.

2. Using a small screwdriver, slowly adjust the trimmer

for maximum output from the radio.

NOTE:  The Antenna Trimmer only affects AM reception,

and will have no effect on FM reception.  The
Trimmer only needs to be adjusted when the
radio is first installed and at any time a change
is made to the vehicle antenna (replacing the
mast, etc.).

8

This selector switch is incorporated to allow maximum
reception in both weak and strong FM signal areas.  For
normal reception conditions and when receiving a wide
range of signals including weak or distant stations, the
switch should be set to the “in” position, which will allow